Tomeet increasing requirements on efficiency and cost-saving ofconstruction work, more and more structures are made of prefabricatedconcrete parts. In this respect, suppliers offer a wide range ofspecial solutions, and individual ones, too. However, makingwater-tight joints between the prefabricated parts is connected withsome problems. Sealing with swelling mortar, or with additional sealsplaced outside is both unsafe and expensive. Pre-fabricated sealingsystems are only available for standard sizes, and their use in pressurised water areas is restricted.

RubberElast^®,our innovative sealing tape for joints between prefabricated concretecomponents offers a solution allowing for a quicker progress ofconstruction work through the easiest handling and most flexible use.

RubberElast^®is to be mounted by simple pressing onto a oint of a concretecomponent. It immediately and tightly seals the joint against water,through contact pressure of the concrete component which is put on it.Thereby the sealing tape also covers imperfectly made joint surfaces ornon-uniformities of the joint run. Moreover, the sealing tape featuresenormous water and gas impermeability, as well as excellent resistanceagainst wear caused by weather or mechanical influence.

Due to its high elasticity, RubberElast^®even can equalise joint displacements up to 7 mm. At the same time, thematerial keeps its good qualities and features at low temperatures, aswell. The sealing tape is also characterised by excellent adhesionproperties with regard to metals, glass and other materials.

Due to these advantages, RubberElast^® has been successfully used worldwide since many years.

Sealing of precast concrete components joints with RubberElast^®

Look and see the quality and advantages of our product and do not hesitate to contact us.